Helix Low-Rise Adhesive is ready to use from the container, no mixing required.
The polyurethane foam is applied in a single step. Both parts of the adhesive are ready to use from the container – no mixing required – and are applied simultaneously in a 1:1 ratio through a static mix tip. It is applied in continuous ribbons or beads spaced 4, 6 or 12 inches apart, depending on the project and code requirements. There is no overspray, and it cures in minutes.
Helix Low-Rise Adhesive contains no volatile organic compounds (VOCs), chlorofluorocarbons (CFCs) or hydro chlorofluorocarbons (HCFCs).
It does not require mechanical fasteners, maintaining a puncture-free vapor retarder, preventing thermal bridging and protecting the structural integrity of the roof deck.
The bond created by Helix Low-Rise Adhesive provides wind uplift resistance, allowing it to be used on buildings in higher wind zones. In addition, it provides hail resistance when used as an adhesive for fleece-backed membranes.
Helix Low-Rise Adhesive comes in cartridge twin-pack tubes or two-tank sets. Both include one container of each of the adhesive’s two components – Part A and Part B. Cartridge twin-packs cover approximately 200-600 square feet of roof and tank sets cover approximately 1,000-3,000 square feet of roof, depending on bead spacing.
The cartridges fit most dispensing guns currently available on the market. Tank sets come with a Helix Gun Assembly (25-foot dual-hose with attached spray gun), petroleum packet, wrench, and 10 Tank Static Mix Tips. Contractors need not purchase specialty pumps or spray rigs. No external power source is required to run application equipment.
Be the first to comment on "Roofing Adhesive Features One-Step Application Process"