Standing Seam Roof Clamp Accommodates Variety of Seam Profiles

Dynamic Fastener offers the Standing Seam Roof Clamp, which installs over the clip on a completely seamed, attached roof section a minimum 4 feet or further from the edge with no damage to roof panels or finished seams and no roof penetrations. The clamp accommodates seams up to 1 inch wide, and the unique “flip” design of the DFSSRC-03 allows for fit on both the Butler MR24 and Butler VSR-style seams just by removing the bolts, turning one side of the clamp around the ring and replacing the bolts. According to the company, any roof that meets similar loadings, specifications, and codes of the Butler styles will accept these anchors for safety tie off. 

A safety lanyard, of a maximum length 6-foot length, with a deceleration (shock absorber) device and full body harness should be used with the clamp. Clamps have been tested to meet and exceed the following OSHA standards: 1926.502 (d) (2), (3), (4) and (15): Anchorages for attachments of personal fall arrest equipment.

For more information, visit www.dynamicfastener.com.

Be the first to comment on "Standing Seam Roof Clamp Accommodates Variety of Seam Profiles"

Leave a Reply