Federal Agency Relies on Silicone Coating System to Protects its Roof

The coating forms a seamless membrane. DLA chose to cover the previous gray coating with a white coating finished with granules to minimize heat absorption. Photos: GE Performance Coatings

The coating forms a seamless membrane. DLA chose to cover the previous gray coating with a white coating finished with granules to minimize heat absorption. Photos: GE Performance Coatings

The cold, snowy winters and hot, wet summers in Scotia, New York, put immense stress on local buildings’ roofs. A damp climate with conditions that often involve standing water can take a toll on conventional roof coatings. That was the reason the federal Defense Logistics Agency (DLA) first chose a waterproof silicone roof coating for its Scotia facility in 1996.

“Most building owners in this area spend thousands, sometimes hundreds of thousands, each year keeping their roofs intact,” says Dave Landry, director of operations for DLA, adding, “After using Enduris by GE, we spend almost nothing in comparison.”

More than two decades later, the coating’s 15-year extended warranty had long run out and DLA was ready to reapply. As in 1996, the alternative to resealing would have been a costly and intrusive tear-off. “We had a terrific first experience with Enduris roof coating,” says Landry. “Twenty-two years later, there was no question about who we’d use.”

Efficient Installation

The GE Performance Coatings team inspected the roof for damage before the work began. After more than two decades of punishing conditions, on average less than five mils of the original 21.5-mil coating surface had worn away. Because silicone coatings are seamless, the roof was also protected from expansion and contraction cycles caused by temperature

More than 20 years after applying a silicone roof coating on the roof of the Defense Logistics Agency in Scotia, New York, PUFF Inc. returned to conduct another installation.

More than 20 years after applying a silicone roof coating on the roof of the Defense Logistics Agency in Scotia, New York, PUFF Inc. returned to conduct another installation. Photos: GE Performance Coatings

fluctuations, which can tear apart dissimilar materials where they overlap. In the end, only 5 percent of the 275,000-square-foot roof required repair—the rest just needed a few more mils of coating. DLA chose to cover the previous gray coating with white coating finished with granules, helping to lower the amount of heat absorbed by the roof and add further protection.

The applicator, PUFF Inc., also experienced the benefits of the silicone coating. “During the seven-week project, we lost only one day to rain,” says Bill Rush, operations manager at PUFF Inc. and an approved applicator for GE Performance Coatings. “If it had been an acrylic coating, we would have likely lost a week to predicted rain delay. Additionally, there were two days that rain came unexpectedly from over the mountains, when the forecast was a 10 percent chance of rain.”

A quicker installation meant savings for the PUFF Inc. team—hotel rooms, per-diem expenses, and the opportunity cost of missing other jobs add up fast. Rush also felt a personal connection to the DLA’s positive experience. “I led the installation 20 years ago,” he says. “It’s a matter of great pride to see how well the system held up.”

TEAM

Roofing Contractor: PUFF Inc., Charlottesville, Virginia, Puffinc.com

MATERIALS

Coating System: Enduris by GE, GE Performance Coatings, GE.com/silicones

Spray Polyurethane Foam Alliance Announces Excellence Award Winners

The Spray Polyurethane Foam Alliance (SPFA) has announced the winners of the 12th Annual SPFA National Industry Excellence Awards. Winners of the industry awards program represent stand out contractors and projects in the Spray Polyurethane Foam sector in both roofing and insulation, as well as in specialty applications. Awards were announced at the awards luncheon held at the Sprayfoam 2017 Convention & Expo in Palm Springs, Calif.
 
“Each year the Industry Excellence Awards allow us to recognize our industry’s contractors and projects,” says Kurt Riesenberg, executive director of the Spray Polyurethane Foam Alliance (SPFA). “This year’s entries set the bar in best practices with the contractors showcased helping to set a tone of excellence in the application of spray polyurethane foam.”
 
The awards program recognizes projects in five categories including: Residential Wall; Commercial Wall; SPF Roof Under 40,000 Square Feet; SPF Roof Over 40,000 Square Feet; Specialty Applications, a category formerly known as Tanks & Vessels & Others.
 
The winners and runners up of the 12th Annual SPFA National Industry Excellence Awards include:

  • Elite Insulation & PolyPro LLC for the Blakemore Estate with supplier Lapolla Industries Inc. (WINNER – Residential Wall Foam)
  • Polyseal and the Mertarvik Sled House with supplier SWD Urethane (Runner up – Residential Wall Foam)
  • West Roofing Systems Inc. for the HyCAL Gibraltar Facility Rehabilitation with supplier Premium Spray Products, an Accella brand (WINNER – Commercial Wall Foam)
  • Tri-County Insulation dba Boss Insulation for the Zinke Dairy Inc. with supplier Lapolla Industries Inc. (Runner up – Commercial Wall Foam)
  • Wedge Roofing for The Mission Church with supplier Premium Spray Products, an Accella brand (WINNER – SPF Roof Under 40,000 Square Feet)
  • West Roofing Systems Inc. for The Leader Building with supplier Accella and Progressive Materials (Runner up – SPF Roof Under 40,000 Square Feet)
  • Puff Inc. for JFK High School with supplier Covestro (WINNER – SPF Roof Over 40,000 Square Feet)
  • Insulation Solutions for Food Processing and Cold Storage Building with supplier Covestro (Runner up – SPF Roof Over 40,000 Square Feet)
  • Elite Insulation & PolyPro LLC for West Main Street Bridge with supplier Lapolla Industries Inc. (WINNER – Specialty Applications)
  • Divine Energy Solutions for Turtle Back Zoo Giraffe House Exhibit with supplier Lapolla Industries Inc. (Runner up – Specialty Applications)

 
“This year’s award entries brought in a number of innovative projects and applications,” says John Achille, president of the SPFA. “While we are limited in the number of awards we are able to bestow, this year saw no shortage of projects and work completed by contractors.”
 
The prestigious awards ceremony is one of many offerings at the Sprayfoam 2017 Convention & Expo. This year’s agenda included onsite exams and training for the SPFA’s Professional Certification Program; a keynote address by author and Emmy Award winner Steve Thomas of PBS’ “This Old House” fame, who is also a current spokesperson for Habitat for Humanity; a 35,000-square-foot exhibit hall showcasing booth displays from over 80 industry organizations, manufacturers, contractors, equipment providers, and many others; a three-day educational program including more than 30 break-out sessions; a general session with Sam Rashkin, chief architect, Building Technologies Office highlighting the Department of Energy’s Net Zero Initiatives; SPFA Annual Member Awards, honoring members who have demonstrated dedication to the betterment of the organization and industry at-large; the Annual Golf Tournament; VIP events; member and contractor-only events; an entertainment filled Close-Out Reception and Networking Party.
 
Attendance for the Sprayfoam 2017 Convention & Expo exceeded 1,200 individuals representing the complete Spray Polyurethane Foam industry and value chain, as well as the general public.
 
To inquire about event sponsorship for the 2018 event, please contact Michele Riesenberg at Michele@sprayfoam.org. Additional event information is available here.

Spray Polyurethane Foam Alliance Announces Board of Directors

The Spray Polyurethane Foam Alliance (SPFA) announces its newly elected board of directors. Representing senior leaders from both the contractor and manufacturer sectors, the fifteen member board includes an executive committee and twelve additional voting members.
 
“Our Board of Directors represents top leaders in the spray polyurethane foam industry,” said Kurt Riesenberg, executive director of SPFA. “With contractors and manufacturers each represented, as well as both insulation and roofing, the SPFA is equipped to take the best course of action for our members and industry.”
 
The SPFA executive committee includes: John Achille, president of SPFA and vice president of Coastal Insulation Corp.; Tiffiny Flaim, vice president of SPFA and president of Biofoam; Richard Spiess, treasurer of SPFA and president of Innovative Insulation Solutions Ltd.
 
Incoming voting members of the SPFA Board of Directors include: Larry Ash, vice president of United Thermal Systems; Teri England, vice president of SmartChoice Insulation & Roofing; Tyler Fiske, spray foam manager of Anchor Insulation; Bryan Heldreth, vice president of RPC Industries; Bonnie Strickler, president and owner of PUFF Inc.; Ron Winkle, president of Roof Asset Management; Mitch Clifton, director of sales and marketing of NCFI Polyurethanes; Doug Kramer, president and CEO of Lapolla Industries Inc.; Nick Pagano, business development manager of Graco; Thomas Sojak, vice president of sales, GacoWallFoam Division of Gaco Western; Joe Stockdale, industry relations manager and commercial manager of Covestro; Ridge Stockdale, national accounts manager of Accella Performance Materials.
 
“This is an exciting time for our industry as we are faced with a multitude of opportunities and challenges,” said incoming SPFA President, John Achille. “Marketshare is growing and demand for the SPF product is up. But we still face difficulties in our sector. I am confident that our new board is more than qualified to lead our organization during this vibrant phase in our industry.”

The current SPFA Board of Directors will be active for the 2016-2018 duration.