The third installment in my series on the roof system is about the substrate board. (To read my first two articles, “Roofs Are Systems” and “Roof Decks”, see the January/February issue, page 52, and the March/April issue, page 54, respectively.) For the purpose of this article, we will define the substrate board as the material that is placed upon the roof deck prior to the placement of thermal insulation. It often is used in part to support vapor retarders and air barriers (which will be discussed in my next article in the September/October issue).
Substrate boards come in many differing material compositions:
• Gypsum Board
• Modified Fiber Reinforced Gypsum
• High-density Wood Fiber
• Mineral Fiber
Substrate boards come in varying thicknesses, as well: 1/4 inch, 1/2 inch, 5/8 inch and 1 inch. The thickness is often chosen based on the need for the board to provide integrity over the roof deck, such as at flute spans on steel roof decks.
The type of substrate board should be chosen based on the roof-deck type, interior building use, installation time of year and the cover material to be placed upon it. For example, vapor retarder versus thermal insulation and the method of attachment. Vapor retarders can be adhered with asphalt, spray foam, bonding adhesive, etc. The substrate board must be compatible with these. You wouldn’t want to place a self-adhering vapor retarder on perlite or hardboard because the surface particulate is easily parted from the board. Meanwhile, hot asphalt would impregnate the board and tie the vapor-retarder felts in better. The substrate board must have structural integrity over the flutes when installed on steel roof decks. The modified gypsum boards at 1/2 inch can do this; fiberboards cannot. If the insulation is to be mechanically fastened, a substrate board may not be required.The substrate board should be able to withstand construction-generated moisture that may/can be driven into the board. Note: In northern climates, a dew-point analysis is required to determine the correct amount of insulation above the substrate board and vapor retarder, so condensation does not occur below the vapor retarder and in the substrate board.
Substrate boards are often placed on the roof deck and a vapor retarder installed upon them. This condition is often used to temporarily get the building “in the dry”. This temporary roof then is often used as a work platform for other trades, such as masonry, carpentry, glazers and ironworkers, to name a few. The temporary roof also is asked to support material storage. Consequently, the substrate board must be tough enough to resist these activities.
The most common use of a substrate board is on steel and wood decks. On steel roof decks, the substrate board provides a continuous smooth surface to place an air or vapor retarder onto. It also can provide a surface to which the insulation above can be adhered. Substrate boards on wood decks (plywood, OSB, planking) are used to increase fire resistance, prevent adhesive from dripping into the interior, provide a clean and acceptable surface onto which an air or vapor retarder can be adhered, or as a surface onto which the insulation can be adhered.
PHOTOS: HUTCHINSON DESIGN GROUP LTD.